Jump to content

Search the Community

Showing results for tags 'layer'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • News
    • Mankati News
  • Mankati Products
    • Mankati E180
    • Mankati mWare
    • Mankati Fullscale XT Plus & XT
    • MankatiUM
    • Materials
  • General
    • Design
    • Tips & Tricks


  • Design
  • Slicer
  • Firmware


  • Community Calendar

Found 1 result

  1. I am printing on a Mankati Fullscale XT, recently I have been experiencing a weird issue where several layers at the beginning re progressively off-centre. I have attached an image below. (I CANNOT ADD A PHOTO, IT FAILS ON UPLOAD EACH TIME???) As shown I am trying to make a simple tower and it slides over by a small amount each time. Does anybody know why this is happening and what i can do to fix the issue?