Jump to content

Search the Community

Showing results for tags 'printing preparation'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • News
    • Mankati News
  • Mankati Products
    • Mankati E180
    • Mankati mWare
    • Mankati Fullscale XT Plus & XT
    • MankatiUM
    • Materials
  • General
    • Design
    • Tips & Tricks

Categories

  • Design
  • Slicer
  • Firmware

Calendars

  • Community Calendar

Found 1 result

  1. Before a new printing, examine the nozzle and feeding status by pre-extruding a certain length of filament. Here is the operation of Mankati Fullscale XT Plus. Step 1 to Step 3 is to turn down the print bed, so there will be enough room for the filament extrusion. Prepare - Move axis - 1 mm - Z axis - distance xxx Step 4 to Step 6 is the preheating work. Default preheating option is PLA and ABS, for other higher temperature requirement, please enter into "Control" page to turn up the preheating temperature (Max. 300 centi degree ) return to "Prepare" page- Preheat (e.g PLA) - Preheat PLA 1 (left nozzle) Step 7 to Step 10, when temperature reach target heating temperature, extruding some filaments for examination. The feeding motor won't work if the nozzle temperature is too low to melt the filament. Move axis - 1 mm - Extruder (left nozzle) - distance xxx Step 11 to Step 12, inspecting if the filament could run out of nozzle smoothly and as thick as usual. After observation, everything goes well, let's start the new printing job. Start the print from SD card.
×