Jump to content
Sign in to follow this  
Rexfreund

Mankati Quality again

Recommended Posts

mvm    12

Hmm, does not look very good. What connector is this exactly.

Just last week, after about 3200 hours of printing, the connector on my mainboard for the heatbed had burned through.
I repaired it by soldering a couple of heavier electrical wire to the mainboard and so far, it has been running ok.

What I noticed is that many wires (the braided kind), do not have soldered ends.

Much earlier, I replaced the connector that is dangling beneath the printbed with something more solid and with thicker wiring.

 


 

Share this post


Link to post
Share on other sites

Dear Mankati Fullscale XT Plus users, Mankati Tech team have found a solution to solve this problem, now you never need to worry about heating bed wires burning any more.

Also we will find solutions for other wires

IMG_1285.JPG

Share this post


Link to post
Share on other sites
mvm    12

Thank you for the response.

THAT connector looks a whole lot better :)


Could you also please tell us a bit more about any other updates you are planning to the Mankati Fullscale printers? (If any)

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×